It takes only several seconds of exposure to bright light to start it running. This feature activates after your watch has become completely discharged then exposed to light sufficient for charging. Many Citizen Eco-Drive watches are equipped with a Quick Start Feature.
CITIZEN WATCH MODEL NUMBER LOCATION MANUAL
For multifunction and perpetual calendar models, refer to your owners manual for appropriate procedures. For simple analog models, pull the crown out to the time setting position, leave for 30 seconds, then return to the closed position next to the case. The “All Reset” procedure varies for each citizen eco-drive model. When the Citizen watch has received the charging time recommended in its instruction book, the all reset has been performed and the time has been set, the irregular movement of the hands will stop. The amount of charging time, under varying light conditions, to go from a stopped watch to a one second step is shown in each instruction book. However, after it has reached the above charge level, and the time on the watch is set, it will go back to the normal one second step movement. Second, if the Citizen watch is not set until after it is charged up to a sufficient level where the circuit signals the watch to start the one second step again, it will stay in the Time Reset Advisory mode. While charging is continued, the watch will keep correct time and after sufficient charging, will go back to the regular one second step by itself. Resetting the Eco-Drive Watch to return to normal operation?Īfter the watch has stopped and been restarted by exposure to bright light, it will remain in the Time Reset Warning (hitch movement) mode until one or the other of two things happen.įirst, if the citizen watch is set to the correct time after partial recharging, the hitch movement will change to a two step movement indicating that more charging is needed. The time shown would likely be incorrect and need to be reset after recharging the watch sufficiently. Why does my watch appear to have lost time, even though it is still running?Ī second important feature, Time Reset Advisory, warns that the citizen watch has stopped completely and then been exposed to enough light to start running again. For simple citizen analog models, pull the crown out to the time setting position for 30 seconds, and then return the crown to the closed position next to the case, then set the time. If you have fully charged your watch and the second hand continues to move in two second intervals, you need to do an all reset of the watch. This may also occur after fully recharging your watch after a complete discharge of the energy cell. It means that the reserve power is getting low and the energy cell needs to be fully recharged by exposing it to light for a period of time. The second hand on my watch jumps two seconds at a time
When this signal is seen, the watch should be exposed to bright light following the recharging guidelines shown in its instruction manual. A very important feature of Citizen Eco-Drive is the Low Charge Warning Mode which as a result of low energy cell voltage causes the second hand to jump two seconds at a time (while still keeping correct time). In normal use, the watch displays the time and the second hand moves in one second intervals. The Citizen Eco-Drive Energy Cell will last a lifetime of use. The electrical energy is then stored in a special energy storage cell. The Citizen Eco-Drive watch uses a microns thin disc of amorphous Silicon under the dial to convert light energy into electrical energy through the photovoltaic process. Eco-Drive ability to convert light energy to electrical energy means that its power is limitless. A combination of solar conversion panel and energy cell is the power provider for these watches.
CITIZEN WATCH MODEL NUMBER LOCATION HOW TO
Citizen Eco-Drive Watches: How to use and maintain?Ĭitizen Eco-Drive watches use the simplest, yet most advanced power generating and storage system.
0 kommentar(er)
